Step 1
Unpack all of the Framing Table components and remove them
from the pallet. Carefully lay the components out on the floor
and make sure you have everything needed to begin the assembly
process.
Tools Required for Installation: Flat screwdriver, 1/2” socket
and wrench and a 1/4” hex wrench.
Step 5
With the help of others, lift the table into an upright position to
continue with the assembly process. See figure 3 above.
Step 2
Lay clamping table face down on a flat surface. See figure 1.
Step 3
Remove the four hex bolts from the back of the table frame to
prepare it for attaching the legs.
Step 4
Place the legs in position so that the adjustable feet are pointing
towards the bottom fence. Place hex bolts through frame legs,
tighten securely as shown in figure 2.
Follow the steps below for assembling your new Kreg Framing Table.
If you have any questions, please give us a call at 1.800.447.8638.
Step 6
Remove the black plastic end cap from the bottom frame rail
with a flat screwdriver to reveal the socket head stop bolt & nut.
See figure 4 below.
Pry off black plastic end cap with a screwdriver.
Lay table surface fl at.
Tighten leg bolts securely.
Assembly Instructions
4.
4-
Figure 1
Figure 2
Figure 3
Figure 4
Hex Bolts
