Clamping Cylinders
Each of the four clamping cylinders included with this framing table throw
over 400 lbs. per square inch of pressure on the joint line. Each clamping
cylinder can be moved independently of every other cylinder by simply
sliding it up and down the transfer arm. A toggle switch is located on the
top of each cylinder assembly that controls air flow to that particular
cylinder. Each cylinder can then be turned on or off independently of the
other cylinders. In addition, a master switch is located at the bottom of the
transfer arm that has the ability to control all of the cylinders at one time
(if they are in the “on” position).
To Clamp and Join a Frame:
1) Place workpiece into alignment with squaring fence
2) Adjust clamp pad so that it is directly over the joint line
3) Throw cylinders independently or all at once with the master switch
4) Drive screws and repeat process
ing
Figure 1
Figure 2
Figure 3
Figure 4
Place workpiece into alignment with squaring fence
Adjust clamp pad so that it is directly over the joint line
Throw cylinders independently or all at once with the master switch
Drive screws and repeat process
Operating Instructions - Clamping Cylinders
6.
4-
