If you are replacing a failing microprocessor, go to “Closing the cover and
connecting cables” on page 113.
Removing and replacing the hard disk drive
1. Remove the cover. See “Removing the cover” on page 92.
2. Rotate the drive bay assembly upward to gain access to the hard disk drive
cables.
*XXXXXXXXX*
*XXXXXXXXX*
3. Disconnect the signal and power cables from the rear of the hard disk drive.
4. By pulling on the blue handle, lift the hard disk drive and bracket up to
remove it from the drive bay.
*XXXXXXXXX*
*XXXXXXXXX*
5. Note the orientation of the hard disk drive in the plastic bracket.
6. Remove the drive by flexing the plastic enough to slide the drive out.
7. Install the hard disk drive into the plastic bracket by flexing the plastic
enough to slide the drive in.
8. Install the hard disk drive and bracket into the bay until it snaps into position.
9. Reconnect the signal and power cables to the hard disk drive.
10. To complete the installation, go to “Closing the cover and connecting cables”
on page 113.
Chapter 8. Replacing FRUs (Types 8095, 8141, 8142, 8145, 8420, and 8421) 109
