6
MJ
MT
HC
Small holes
Large
holes
Required For This Page:
9/16” Wrenches
(2)
(2)
(2)
MJ
AM
HCMTBC
BC
(2)
1039829
Screwriver
TP
6.1 Completely tighten the Nuts.
6
PA
(1)
1005748
WARNING
The poles must be seated together!! Even if the poles cover the slots
before seating, you must strike them on the wood five to six times!! Failure
to seat the poles correctly could allow the poles to separate during use,
which could lead to serious personal injuries or property damage as
listed on Page One.
9
TP
This step cannot be reversed.
MP
Warning: If the Top and Middle Poles do not completely cover
the slots on the Middle and Bottom Poles after seating, DO NOT
COMPLETE ASSEMBLY. Call our Customer Service Department.
9.1 Strike each end of the Pole firmly 5 to 6 times on a piece of
scrap wood or cardboard.
Warning: Do not hit your feet with the pole sections, as
serious injury could occur.
8
Note: The Screw will spin freely once
installed.
8.2 Insert a 1/4” x 3/4” Screw (PA)
through the small hole in the Top Pole
and into the Middle Pole.
PA
TP
MP
8.1 Align the hole in the Top Pole with the
slot in the Middle Pole and slide the Top
Pole over the Middle Pole.
Do not jam the poles together until instructed.
7.1 Apply the Height Sticker (AL) so it wraps
around the opposite side of the pole as the
Spring Bracket (AM).
Note: The small notch in the Sticker
fits around the hole in the pole.
AL
AM
7
Note: There are two screw holes at the
bottom of the pole. The correct hole will
be slightly larger and slightly higher up on
the pole.
AN
AS
10
AN
AS
Zip Tie (AK)
Larger End
10.2 Use pliers to tighten the Zip Ties (AK) securely. Cut off the ends of the Zip Ties.
Zip Tie (AK)
10.1 The bottom of the Bellows (AS) overlaps the Gas Spring (AN) by 1”. The
top is 1/2” from the top of the Spring.
