A SERVICE OF

logo

Open as PDF
next previous
2.1 Calibration Gage
2.1.1 With-holder type：
z The center point of the gage, which is indicated by an arrow (Æ), is the calibration point.
z Set up the gage on the stand so that the laser beam is aligned with the vertical line ( | )
marked on the side of the gage holder.
2.1.2 Straight type：
z The center point of the marks ( || ) of the gage, which is indicated by an arrow (Æ), is the
calibration point.
z Set up the gage on the stand so that the mark ( | ) on the end face of the gage comes to
vertical.
2.1.3 Stepped type：
z The center point of the gage, which is indicated by an arrow (Æ), is the calibration point.
z Set up the gage on the stand so that the mark ( | ) on the end face of the gage comes to
vertical.
Stepped type Straight type With-holder type
No. 99MBC094A
2-2