88
EN
5
Playback functions
Protecting selected frames
During index display you can select multiple images and protect them all at the same time.
1 During index display, select the images you want to protect using k, then press
the i button.
• The selected images will be shown with v.
• To cancel your selection, press the i button again.
2 Press k to select the next images you want to protect, then press the i button.
3 After you have selected the images to protect, press the 0 button.
Canceling all protections
This function lets you cancel the protection of several images at one time.
1 MENU[q][RESET PROTECT]
2 Use fg to select [YES], then press the i button.
x Notes
• Formatting the card erases all images even if they have been protected.
g“Formatting the card” (P. 127)
• Protected images cannot be rotated even when the F button is pressed.
Lets you erase recorded images. You can select single-frame erase, which erases only the
currently displayed image; all-frame erase, which erases all the images stored on the card; or
selected frame erase, which erases only the frames selected.
x Notes
• When you perform all-frame or selected frame erase on images recorded using RAW+JPEG,
both the RAW and JPEG images are erased. When using single-frame erase, you can select
whether to erase the JPEG, RAW, or both RAW and JPEG images.g“RAW+JPEG
ERASE” (P. 106)
• Protected images cannot be erased. Cancel protected images, then erase them.
• You cannot restore images which have been erased. Be careful not to erase important data.
g“Protecting images” (P. 87)
Erasing images
s0026_e_00_0_unified.book Page 88 Tuesday, September 29, 2009 10:30 AM
