9. Programmable Features
65
Setting the Caller ID list to
print automatically
{#}{2}{1}{6}
{0} “Off” (default): The unit will not print the Caller ID list, but will keep records
of the information for the last 30 callers.
{1} “On”: The unit will print the Caller ID list automatically after every 30 new
calls (page 58).
Setting the time adjustment
{#}{2}{2}{6}
Using this feature, the unit’s date and time setting will be automatically adjusted
when caller information is received.
{1} “Auto”: The date and time setting will be automatically adjusted.
{2} “Manual”: Deactivates this feature.
Note:
L The default may vary depending on feature #114 setting.
Setting the recording paper
size in the standard input tray
{#}{3}{8}{0}
{1} “Letter”: Letter-size paper
{2} “A4” (default): A4-size paper
{3} “Legal”: Legal-size paper
{4} “216×330”
{5} “216×340”
Note:
L When you set feature #147 to “Inches”, the numbers are displayed in
inches.
Setting the recording paper
size in the lower input tray
{#}{3}{8}{2}
This feature will be displayed only when the lower input tray is installed (page
85).
{1} “Letter”: Letter-size paper
{2} “A4” (default): A4-size paper
{3} “Legal”: Legal-size paper
{4} “216×330”
{5} “216×340”
Note:
L When you set feature #147 to “Inches”, the numbers are displayed in
inches.
Setting the recording paper
type
{#}{3}{8}{3}
{1} “Plain Paper”: 75 g/m
2
to 90 g/m
2
paper.
{2} “Thin Paper” (default): 64 g/m
2
to 75 g/m
2
paper.
{3} “Thick Paper”: 90 g/m
2
to 165 g/m
2
paper.
Note:
L This setting is valid for both the standard input tray and the lower input tray.
L “Thick Paper” will not be displayed if any of the paper input tray settings
are changed to “#2” or “#1+#2”:
– fax (feature #440 on page 70).
– copy (feature #460 on page 73).
–PCL
®
(feature #760 on page 75).
– scan to email print feature (feature #565 on page 80).
Setting the waiting time for
the power save mode
{#}{4}{0}{3}
To set the length of time before the unit enters power save mode.
{1} “5min”: 5 minutes
{2} “15min” (default): 15 minutes
{3} “30min”: 30 minutes
{4} “1h”: 1 hour
Note:
L When in power save mode, the unit needs to preheat the fuser unit before
it can begin printing.
Holding the previous contrast
setting
{#}{4}{6}{2}
{0} “Disabled” (default): Deactivates this feature.
{1} “Enabled”: The unit will hold the previous setting.
Note:
L The previous setting will be held individually for copying and sending faxes.
Feature/Code Selection
