178
Using the Flash
5
Using a Combination of the Built-in Flash and an External Flash
Unit
1
Remove the external flash unit after the channel was set
on the camera, and place at the desired location.
2
Set the flash mode of the camera to r, and press the E
button.
3
Confirm that both flashes are fully charged and then take
the picture.
Using a Combination of External Flash Units
1
Set the wireless mode of the external flash directly
connected to the camera to [MASTER] or [CONTROL].
2
On the wireless remote flash unit, set the wireless flash
mode to [SLAVE] and set the channel to the same channel
as the flash directly connected to the camera. Then, place
at the desired location.
3
Confirm that both flashes are fully charged and then take
the picture.
Wireless Shooting
MASTER
Discharges both the flash directly connected to the camera
and the wireless flash unit.
CONTROL
The flash directly connected to the camera is discharged as
a control flash only and does not discharge as main flash.
• [Shake Reduction] and [Horizon Correction] are automatically turned off in
the wireless mode.
• When using multiple AF540FGZ/AF360FGZ external flashes and performing
high-speed flash sync shooting in the wireless mode, set the flash directly
connected to the camera to high-speed flash sync mode.
