29
Care and maintenance
These maintenance intervals are calculated for the average running time of a
single shift operation. If the machine is operated more than this, shorter inter-
vals are recommended.
10.02 Cleaning the machine
The cleaning cycle required for the machine depends on following factors:
● Single or several shift operation
● Amount of dust resulting from the workpiece
It is therefore only possible to stipulate the best possible cleaning instructions for each indi-
vidual case.
For all cleaning work the machine must be disconnected from the mains
by switching off the on/off switch or by removing the mains plug!
Danger of injury if the machine suddenly starts up .
The following tasks are recommended dur-
ing single shift operation to avoid operation-
al errors:
● Tilt machine backwards.
● Clean the clamps and clamp area daily, or
more often during long-term usage.
● When righting the sewing head, ensure
pressing the anti-tipping device 1.
Return the machine to its up-
right position using both hands!
Danger of injury by crushing be-
tween the edge of the
machine and the table top!
Fig. 10 - 01
Clean the hook compartment ................................Daily, several times if in continuous use
Clean the entire machine ..................................................................................once a week
Check oil level .................................................................................................once a month
10 Care and maintenance
10
.01 Servicing and maintenance intervals
1
