Manual-6
Maintaining Magnetic Faders
ere are no electrical contacts to clean!
e faders in the TTM 56S are designed with materials highly
resistant to corrosion and most chemicals. While the faders will
handle millions of operations, they may become dirty over time.
Bad things may be spilled or sprayed into the faders. In either case,
the faders are not damaged and the sound quality is unaected.
Cleaning is only required to maintain the feel of the faders.
e faders are self-lubricating and with normal use, should
not require additional lubrication. If you wish, you can use a light
silicone lubricant rated for use with electrical parts. is will help
maintain the feel. We recommend Caig DeoxIT FaderLube
F100
spray lubricant.
Order DeoxIT® F100 from CAIG Laboratories, Inc.
12200 atcher Ct.
Poway, CA 92064
Phone 858-486-8388
Fax 858-486-8398
Web www.caig.com
Never use a heavy lubricant or grease. Doing so will not
damage the faders, but can undo the feel. If grease was used, it may
be removed by following the cleaning instructions. Light lubrica-
tion is possible with the Lexan plate on. A couple of drops or a
short spray are all that is required. Make sure the products you use
are suitable for use with electrical parts that contain plastic.
Magnetic Slider Rail Cleaning
a. Move the carrier all the way to one side.
b. Use a soft lint-free cloth to wipe o rails.
c. Add a drop of silicone lubricant (or quick spray from aerosol) to the center of each rail.
d. Move the carrier back and forth to distribute lubricant.
e. Do not bend torsion spring or touch sensors.
Magnetic Fader Q and A
Q: Will I damage the faders if I spray them with bad stu or
spill bad things in them?
A: No. e faders in the TTM 56S are designed with materials
highly resistant to corrosion and most chemicals. ere are no
electrical contacts to clean or damage. While bad things may
change the feel of the faders, bad things will not aect the
sound. To clean faders that have had a bad thing put in them,
follow the simple instructions on page Manual-8.
Q: Can I install magnetic faders in any other mixer?
A: Sorry. e connectors may be similar, but the circuits are very
dierent. Connecting the faders to anything other than the in-
tended cable in the TTM 56S could permanently damage them.
Q: Can I install other faders in my TTM 56S?
A: No. e cable connections are specially designed for Rane mag-
netic faders.
Q: Can I install a dierent magnetic fader in my mixer or swap
the position of my faders?
A: No. In order to achieve the highest possible accuracy, each
magnetic fader is factory calibrated for the location in which it
was shipped. For information about replacement or calibration,
contact Rane Customer Service. If you remove the faders for
cleaning, make sure you mark them. is helps you to put them
back in the same location.
Q: Is the same fader used in the TTM 56 as the TTM 56S?
A: Yes. We nally get to say yes.
Sensors
