Regency
®
E33S-1 Sunrise Gas Insert 17
INSTALLATION
GLASS DOOR INSTALLATION
INSTALLATION
To install the glass door, simply hook the top door fl ange onto the top of
the unit and swing the door towards the unit, (see Diagrams 1 and 2). Be
careful that the glass gasket does not roll up; there must be a gap between
the gasket and the door lip to ensure that the door sits securely on the
unit. Refer to Diagram 3.
Diagram 3
Secure door by fastening with two screws located at bottom of glass door,
refer to Diagram 1.
Diagram 2
Screws
Diagram 1
GLASS CRYSTAL OR OPTIONAL CERAMIC STONES
INSTALLATION
Glass Crystals shown on Burner
Optional Ceramic Stones shown on Burner
Colbalt Glass Crystals/Ceramic Spa Stones Quantity
Colbalt Crystals Ceramic Spa Stones
P33S 1 bag 70*
E33S 1 bag 70
L676S 1 bag 70
*Recommended to use only 50 of the 70 ceramic stones on the P33S
burner.
Spread the supplied Glass Crystals (or optional Ceramic Spa Stones)
evenly over the burner. Ensure the crystals (stones) do not overlap too
much as this will effect the fl ame pattern.
NOTE: When installing, use either the supplied Glass Crystals or optional
Ceramic Spa Stones - DO NOT combine the two when installing on Models
P33S/ E33S/ L676S. Only the supplied approved Cobalt Blue Glass or
optional Ceramic Spa Stones are to be used with this fi replace. Use of
any other type of glass crystals or ceramic stones can alter the unit's
performance, any damage caused by the use of any unapproved glass
or stones will not be covered under warranty.
NOTE: When using Ceramic Stones, DO NOT cover burner ports that
lead to pilot fl ame.
