11
Care and Maintenance
Clean the TruTrack Ultrasonic Leak Detector with mild soap (such as
dish soap) and a damp cloth. Remove the battery and close the battery
compartment door before cleaning. Do not allow water to enter the unit,
especially in the front where the sensors are located.
After cleaning, dry the unit with a paper towel. Restore the luster by
applying an automotive vinyl cleaner with a clean cloth.
Remove the battery if you plan to store the unit for an extended period of
time.
Battery Installation
1. Turn the unit upside down so the controls are facing the oor and
the sensor is facing away from your body.
2. Locate the sliding battery door on the back of the unit, at the
opposite end from the sensors.
3. Apply light pressure to the center of the battery door, and slide it
toward you, exposing the battery compartment.
4. Install a fresh 9-volt battery, using the (+) and (-) indicators, which
are printed on the label, for positioning the battery.
Calibration
TruTrack Ultrasonic Leak Detectors are designed to minimize the need
for regular calibrations. If there is a need to know for sure that the
detector is consistent with the manufacturer’s specications, or if you
suspect a problem, Robinair will perform the calibration at a xed cost.
Call 1-800-822-5561 for current calibration costs.
For service and repairs contact:
Robinair
655 Eisenhower Drive, Owatonna, MN 55060
Phone 1-800-822-5561 • Fax 1-800-822-7805
Maintenance
