LATEX WATER BASE PAINT
1. Use nozzle Tip 8004EVS.
Completely fo2. llow mixing instructions on paint container. The solids must be in
suspension.
3. To agitate paint in the LINE STAR, see “Agitating Instructions.”
4. Never use mixed paint without straining.
The depth of color of the line will be determined by the percentage of water added to
the paint. The user must decide for himself the consistency because of the variatio
in paints that are obtainable
5.
n
. The spray gun and nozzle tip should be disassembled for cleaning.
ted
sliding the rod to the desired position and then locking with tightener provided.
fore starting - Use 10W30 oil
d when
“B” OPEN AT THE SAME TIME.
ine.
9. Relief valve can be adjusted to desired pressure. To adjust:
ase through the exhaust
e.) Tighten locknut to secure adjustment setting.
. In most cases, the probable mix should be at least 2
parts water to 1 part paint.
6. Always drain and flush entire liner with water after each use.
7
TO SET LINESTAR
The line width desired can be set by loosening 1. the wing nuts on the spray box and
moving the side plates in or out from 2” to 5”.
Locate the line guide squarely on the line intended. The line guide can be adjus2.
TO OPERATE
Add oil and gas to engine be
1. Valve “A” must be open.
2. Valve “B” must be closed.
3. Valve “C” must be closed.
If spray gun4. is attached, the Valve (Ref. #7, Figure V, #40-048) must be close
not in use.
NOTE: NEVER HAVE VALVES “A” AND
5. Prepare paint mixture and pour into tank.
6. Screw tank cap on tightly.
7. Check the engine manual for operating instructions, start eng
8. The regulator is pre-set to operate up to 45 PSI.
a.) Loosen locknut of relief valve.
b.) Screw adjustment nut all the way into the valve.
c.) Charge tank to desired pressure setting.
Unscrew adjustment nut ud.) ntil air begins to rele
port in the top of the nut.
11
OPERATING INSTRUCTIONS (Continued)
lve on the handle bar.
10. You can now operate the liner by the hand va
