48
Playback
Chapter 3 Recording and Playback
Setting the current tape position as point A
or B
While holding down the SET (YES) button in the menu
control section, press the </A or ,/B button. The
timecode value of the current tape position is set as point
A or B, and a message “A set” or “B set” is displayed for
0.5 second in the time counter display.
Once set, the point A or B timecode value is held in the
non-volatile memory of the unit until changed. It is not lost
when the unit is powered off.
When setting point A or B, you can only use a timecode
value. Even when CNT is selected with the COUNTER
SELECT button, you cannot use a CNT value to set point
A or B.
To check the point A or B timecode value
Press the </A or ,/B button in the menu control
section. While the button is held down, the point A or B
timecode value is displayed on the monitor screen and in
the time counter display.
If you hold down the </A and ,/B buttons
simultaneously, the value shown is the point B timecode
value minus the point A timecode value. If the point A
timecode value is greater than the point B timecode value,
a minus sign (–) is shown before the value.
Inputting timecode values for points A and
B
Using the following procedure, you can modify the
timecode value for point A or B.
1
Press the MENU button.
The following menu display appears.
2
With SETUP MENU selected, press the ,/B
button.
The display changes as follows.
3
With OPERATIONAL FUNCTION selected, press
the ,/B button.
The display changes as follows.
4
With REPEAT FUNCTION selected, press the ,/B
button.
The contents of the REPEAT FUNCTION menu item
are displayed.
Note
PRESET
VARIABLE
REC
PB
LEVEL
MONITOR
SELECT
COUNTER
SELECT
PHONES
CONTROL-S
REW PLAY F FWD
i.LINK
1 2
VIDEO
3
A B
CH1 1/2
4
CH2 3/4
OVER
CH
1
0
-12
-20
-30
-40
-60
RECSTOP
TC VITC44.1K
OVER
REPEAT 1080 525
CH2
EDIT MODE
REC INHI
EJECT
LOCAL
i.LINK
HDV
DVCAM
(DV)
9PIN
01:23:45:15
INPUT SELECT
REC/PB LEVEL
POWER
DISPLAY MENU
A B
MENU
RESET(NO)
SET(YES)
TC
PRESET
ASSIGN
RESET(NO)
SET(YES)
TC
PRESET
ASSIGN
Buttons used for setting
the current tape position
as point A
Buttons used for setting
the current tape position
as point B
A B
MENU
RESET(NO)
SET(YES)
TC
PRESET
ASSIGN
5,7,9,12
13
12
8,11
1,15
2,3,4,6,
10,11
Setup menu
SYSTEM MENU
SETUP MENU
AUTO FUNCTION
HOURS METER
Monitor screen
Time counter display
Operational
SETUP MENU
OPERATIONAL FUNCTION
DISPLAY CONTROL
TIME CODE
SETUP BANK OPERATION
SYSTEM SEL : J
MENU GRADE : BASIC
Monitor screen
Time counter display
> REP FUNC
SETUP MENU
OPERATIONAL FUNCTION
REPEAT FUNCTION
AUTO EE SELECT
LOCAL ENABLE :STP&EJ
REC FORMAT
Monitor screen
Time counter display
