32 Sun Blade T6300 Server Module Administration Guide • April 2007
ttya-mode 9600,8,n,1,- 9600,8,n,1,- Serial management port (baud rate, bits,
parity, stop, handshake). The serial
management port only works at the default
values.
output-device virtual-
console, ttya
virtual-
console
Power-on output device.
input-device virtual-
console, ttya
virtual-
console
Power-on input device.
auto-boot-on-error? true, false false If true, boost automatically after system
error.
load-base 0-n 16384 Address.
auto-boot? true, false true If true, boots automatically after power
on or reset.
boot-command variable-name boot Action following a boot command.
boot-file variable-name none File from which to boot if diag-switch?
is false.
boot-device variable-name disk net Devices from which to boot if
diag-switch? is false.
use-nvramrc? true, false false If true, executes commands in
NVRAMRC during server startup.
nvramrc variable-name none Command script to execute if
use-nvramrc? is true.
security-mode none, command,
full
No default Firmware security level.
security-password variable-name No default Firmware security password if
security-mode is not none (never
displayed). Do not set this directly.
security-#badlogins variable-name No default Number of incorrect security password
attempts.
TABLE A-1 OpenBoot Configuration Variables Stored on the System Processor (Continued)
Variable Possible Values Default Value Description
