Filter
Top Products
Page 16 AMERICAN SANDERS TECHNOLOGY Classic 8 Operator's Manual
Figure 15
Leveling
To adjust the machine leveling follow this procedure:
1. Locate the leveling screw. See figure #15. The
leveling screw is located towards the rear of the
chassis beneath the sanding pressure knob.
2. Tighten the leveling screw (compress the leveling
spring) to sand heavier on the drive belt side.
3. Loosen the leveling screw (relax the leveling
spring) to sand heavier on the side opposite the
drive belts.
Belt Tracking
WARNING: Injury to the operator could
occur if any machine adjust-
ments are made while the motor
is running. Do not attempt to
make any adjustments while the
machine is plugged in or
running.
To adjust the belt tracking follow this procedure:
1. Locate the belt tracking adjuster screw. See
figure #16a.
2. Hold the belt tracking adjuster screw and loosen
the locknut. See figure #16b.
3. Rotate the tracking adjuster screw counterclock-
wise to move the belt in.
4. Rotate the tracking adjuster screw clockwise to
move the belt out.
5. Test adjustment and tighten the locknut.
Operating Control
To increase the travel or extend the reach on the grip
control follow this procedure:
1. Loosen the locknut on the control rod. See figure
#17.
2. Screw the control rod adjuster in until the
desired reach is found.
3. Tighten the locknut.
To decrease the travel or reduce the reach on the
grip control follow this procedure:
1. Loosen the locknut on the control rod. See figure
#17.
2. Screw the control rod adjuster out until desired
reach is found.
3. Tighten the locknut.
Figure 16
Figure 17
IVIE Enterprises
www.ivie-ent.com Ph:(918)254-5161 or (888)262-5161 Fax:(918)250-4807