Anton/Bauer DUAL 2702 Battery Charger User Manual


 
6
1 - - - - - - - 2 - - - - - - -
LCD Indications
Each PowerCharger’s liquid crystal display (LCD) will display the status of each
battery, as well as, important PowerCharger operating indications. The following
information explains the indications which appear in the LCD.
The levels of the LCD display on each PowerCharger can be obtained by pressing the
DISPLAY, or in some cases TEST, button on the PowerCharger front panel.
The Main Display shows the general status of each
battery mounted to the PowerCharger. This
display is immediately returned to following self
test and after viewing any other screen.
Both the two position (above) and four
position Main Displays will show a series of
dashes when a battery has not been mounted to
the PowerCharger.
The Main Display of the PowerCharger will show
the abbreviated status of each battery on the main
unit.
The Signature Display can be viewed by pressing
and holding the TEST button from the Main
Display on the PowerCharger to obtain model
information, Software revision number and
installation of DDM (discharger).
The Primary Position Display is obtained by
pressing the DISPLAY button repeatedly until
the position number for the battery desired is
displayed. This view further identifies the status
of the battery, its model number (chemistry and
voltage), as well as current battery voltage.
The Primary Position Display will additionally
display the available capacity
when a DIGITAL
battery is used, both in percent and in ampere
hours.
The Secondary Position is obtained by pressing
and holding the DISPLAY button while viewing
the primary position display. This Secondary
display is available only
with DIGITAL
batteries and is used to obtain information
transmitted from the battery to the charger
including battery serial number, date of
manufacture, number of cycles, “learned”
capacity, type of stage one charging cut-off
experienced and battery temperature.
2—Ser# 96280 Mar98 4.0
118 cycles VCO 27
o
C
1 - - - - - - - 2 - - - - - - -
3 - - - - - - - 4 - - - - - - -
2—READY (Lifesaver) 4.0
PROPAC 14D 100% 16.5 V
1—Waiting to Charge
PROPAC 14 16.5 V
1—WAIT 2—READY
3—CHARGE 4—READY
DUAL 2701 Rev. #3.xx
Discharger NOT INSTALLED