Filter
Top Products
Page 11For technical questions, please call 1‑800‑444‑3353.SKU 68022
OPERATING INSTRUCTIONS
Read the ENTIRE IMPORTANT
SAFETY INFORMATION
section at the beginning of this
manual including all text under
subheadings therein before set up
or use of this product.
Inspect tool before use, looking
for damaged, loose, and missing
parts. If any problems are found,
do not use tool until repaired.
Work Piece and Work Area Set Up
1. Designate a work area that is clean and
well-lit. The work area must not allow
access by children or pets to prevent
distraction and injury.
2. Route the air hose along a safe route to
reach the work area without creating a
tripping hazard or exposing the air hose
to possible damage. The air hose must
be long enough to reach the work area
with enough extra length to allow free
movement while working.
3. Secure loose workpieces using a vise
or clamps (not included) to prevent
movement while working.
4. There must not be hazardous objects
(such as utility lines or foreign objects)
nearby that will present a hazard while
working.
General Operating Instructions
1. Test the Tool, as directed in the prior
section, before each use.
2. If an automatic oiler is not used, add a
few drops of Pneumatic Tool Oil to the
airline connection before use. Add a few
drops more after each hour of continual
use.
3. Set the working air pressure on the
regulator to between 60 and 120 PSI.
Do not exceed 120 Max. PSI.
4. Slide the Nail Length Slider (44) to match
the corresponding pin length (1/2”, 5/8”,
3/4”, 7/8” or 1”) of the fasteners loaded
in the Nailer. See Figure 1, below, which
shows 1” pin length setting.
NOTE: When changing pin size, slide
the Nail Length Slider to the new length
BEFORE inserting the new pins.
Loading the Tool
TO PREVENT
SERIOUS INJURY
FROM ACCIDENTAL OPERATION,
BEFORE LOADING:
• Wear ANSI‑approved safety
goggles with side shields. Other
people in the work area must also
wear ANSI-approved impact safety
goggles with side shields.
• Release the Trigger.
• Detach the air supply.
• Attempt to re the Tool into a
piece of scrap wood to ensure
that it is disconnected and is
incapable of ring any fasteners.
1. Depress the Latch (55) and pull back on
the Magazine Cover (45), fully extending
it out from Magazine (38, 41).
Operating Instructions
Nail Length Slider (44)
Figure 1