Filter
Top Products
11
Note:
1. Each command and feedback is terminated with a carriage return.
2. Spaces aren’t allowed except in projector display on/off command strings.
3. AT-HDVS-RX RS-232 port settings:
115200 bps, 8 bit data length, No parity bit, 1 bit stop-bit, No flow control.
4. Feedback for a command repeats the original command.
5. If a command fails or is aborted, the feedback will be “COMMAND FAIL”.
6. Some commands support query function by parameter [?]
Example: To get projector’s display on command -> WP_DisplayOn[?]$
To get input status -> WP_Input[?]$
Commands cont.
WP_AutoDispOn[a]$ [a] ? , On , Off Set auto [Dispaly On] enable/disable
WP_AutoDispOff[a]$ [a] ? , On , Off Set auto [Dispaly Off] enable/disable
WP_HdcpInput[a]$ [a] ? , HDCP , NotHDCP, Auto HDCP input mode
WP_VgaAuto[a]$ [a] Go Run VGA source auto-adjust
WP_VgaClock[a]$ [a] ? , Normal , Inverse Set VGA ADC clock polarity
WP_Info[a]$ [a] ? Get RX firmware version
WP_InfoTx[a]$ [a] ? Get TX / TX-WP firmware version
WP_Output[a]$ [a] ? , 0 , 1 , 2 ... (map osd menu Output list) Select output resolution
WP_OverscanEn[a]$ [a] ? , Yes , No Set overscan enable/disable
WP_OverscanH[a]$ [a] ? , 0 ~ 50 Set overscan H size (%)
WP_OverscanV[a]$ [a] ? , 0 ~ 50 Set overscan V size (%)
WP_AudioEn[a]$ [a] ? , On , Off Set audio out On/Off
WP_AudioHdmi[a]$ [a] ? , On , Off Set hdmi audio out On/Off
WP_AudioLR[a]$ [a] ? , On , Off Set analog L/R audio out On/Off
WP_SystemRst[a]$ [a] Go Run system reset
WP_PictureBri[a]$ [a] ? , + , - , 0 ~ 100 Set picture brightness
WP_PictureCon[a]$ [a] ? , + , - , 0 ~ 100 Set picture contrast
WP_PictureSat[a]$ [a] ? , + , - , 0 ~ 100 Set picture saturation
WP_PictureHue[a]$ [a] ? , + , - , 0 ~ 100 Set picture hue
WP_PictureSha[a]$ [a] ? , + , - , 0 ~ 100 Set picture sharpness
WP_PictureRst[a]$ [a] Go Run picture reset
WP_ProjSW[a]$ [a] ? , 0 , 5 , 10 , ~ 300
WP_Standby[a]$ [a] ? , 0 ~ 10 Standby timer in minute
]$ Abort command, Feedback is
COMMAND FAIL
atlona.com
Toll free: 1-877-536-3976
Local: 1-408-962-0515