Filter
Top Products
© 2008 • All rights reserved. 19
DH44 4 Source, 4 Zone Digital Audio Router
DHTP1 Speaker Connections
The DH44 routes digital audio to connected DHTP1 Touch Pads where the audio is then ampli-
fi ed and sent to in-room speakers.
WARNING!: The DHTP1’s amplifi er is capable of powering a single pair of 8-6 Ohm speak-
ers. DO NOT connect speakers with a rating of less than 6 Ohms! DO NOT connect more
than one speaker to either speaker connector of the DHTP1. In doing this, damage to the
DHTP1 may occur and will void the products warranty.
To connect speakers to DHTP1 Touch Pads:
Ensure that system power is OFF!
Remove the SPEAKER CONNECTOR from the DHTP1
Strip speaker wire back 1/4"
Loosen speaker terminal screws on the speaker connectors
Insert speaker wires into terminals making sure to maintain +/- polarity
Tighten screws on speaker terminals
Re-connect the terminal strip to the SPEAKER CONNECTOR on the DHTP1
Connect speaker wires to the room speakers maintaining correct polarity
L+
L-
R+
R-
AUX Power
Connector
Speaker
Connector
To Speakers
DHTP1 Rear
¼
"
16AWG
Speaker Wire
SPEAKERS
PWR IN
+
-
Figure 3-10: Speaker Connections
1.
2.
3.
4.
5.
6.
7.
8.