Beko WM 7335 W Cordless Saw User Manual


  Open as PDF
of 36
 
EN
22
Preparation
1. Turn the tap on completely. Check if
the hoses are connected tightly.
2. Placethelaundryinthemachine.
3. Add detergent and softener.
Starting
1. Pressthe“On/Off”button.
2. Select the programme and the
temperature.
3. Ifrequired:
– selectanyauxiliaryfunction,
– adjustthespinspeed,
– setthetimedelay,
4. Close the loading door.
5. Press“Start/Pause/Cancel”
button. The display shows the
time remaining for the program to
complete if time delay is not set.
6. Check if the program follow-up
indicator on the screen lights up.
Canceling a program
1. Pressandholdthe`Start/Pause/
Cancel`buttonforabout3seconds;
the“Ready”lightwillstartflashing.
2. The machine can drain all the water
or can take in water for 3 times at
most to cool down the clothes and
complete draining process.
Adding more laundry
• Thisisonlypossibleunderthe
followingconditions:
1. during time delay,
C You may add or remove laundry
duringthetimedelay(untilthe
programstarts).
2. At the beginning of a washing cycle,
C Machineallowsaddingmorelaundry
during a future step only if the water
level is low enough to open the
loading door or if the temperature in
the machine is low
In order to add laundry after the start-up
oftheprogram:
1. Press“Start/Pause/Cancel”
button. Wait for the safety lock to
open. "Ready" lamp will light up
continuously.
2. Opentheloadingdoorandputin
more laundry.
3. Close the loading door.
4. Press“Start/Pause/Cancel”button.
Program is in rinse hold mode
C This process is shown with the
flashing " " symbol.
If you wish to spin when the machine is
inthismode:
1. Adjust the spin speed.
2. Press“Start/Pause/Cancel”button.
Programresumes.Yourmachine
drains the water and spins your
laundry.
If you want to drain the water without
spinning:
Press“Start/Pause/Cancel”button.The
program continues and only drains the
water.
Re-spinning the laundry
The control system for an unbalanced
load can pause the spinning in cases
when the distribution of the laundry in
the drum is not balanced.
Ifyouwanttore-spintheclothes:
1. Rearrange the previously placed
clothes in machine.
2. Select the spin program.
3. Adjust the spin speed.
After the program is finished
Programindicatorlightsonthescreen
remain lighted up after the program is
finished.
1. “End”willappearonthescreen
when“ready”lamplightsupinthe
programfollow-upindicator.Open
the loading door and remove the
laundry.
2. Pressthe“On/Off”button.
3. Turn off the water tap.
4. Eliminate any folding of the rubber
seal on the loading door and check
for impurities.
5. Leave the loading door and
detergent drawer open to dry.
6 Quick instructions for daily use
 previous next