Beko WM 7335 W Cordless Saw User Manual


  Open as PDF
of 36
 
EN
26
Cause Explanation / Suggestion
Programmecannotbestartedorselected.
Machinemayhaveswitchedtoself
protection mode due to an infrastructure
problem(suchaslinevoltage,water
pressure,etc.).
Bring your machine to factory settings by turning the
programmeselectionknob.(see,Endingtheprogramme
throughcanceling)
Water in the machine.
There may be some water in your machine
when you receive it. This is from the quality
control process and is normal.
It is not harmful to your machine.
There is water coming from the bottom of the machine.
There might be problems with hoses or the
pump filter.
-Makesurethatthesealsofthewaterinlethosesare
securely fitted.
- Tightly attach the drain hose to the tap.
-Makesurethatthepumpfilteriscompletelyclosed.
Machinedoesnotfillwithwater
- Tap may be turned off.
- Water inlet hose might be bent.
- Water inlet filter might be clogged.
- The loading door may be ajar.
-Opentheinletwatertapsfully.
- Flatten the water intake hose.
- Clean the water intake filter.
- Close the loading door.
Machinedoesnotdischargewater.
- Water outlet hose might be clogged or
twisted.
-Pumpfiltermaybeclogged.
- Clean or flatten the hose.
- Clean the pump filter.
Machinevibratesorshakes.
-Machinefeetmightnotbeadjusted.
- Transportation safety bolts might have not
been removed.
- There may be a small amount of laundry in
the machine.
- The machine may be overloaded or the
clothes may be distributed unevenly.
- There machine might be touching a solid
surface.
- Adjust the machine feet.
- Remove the transportation safety bolts.
- Add more laundry to the machine.
- Reduce the amount of laundry in the machine or
balance the load by hand.
- Ensure that nothing touches the machine.
Machinestopsshortlyaftertheprogrammestarts.
Machinecanstoptemporarilyduetolow
voltage.
It will resume operating when the voltage is back to the
normal level.
The water being taken in is directly discharged.
Improper position of the drain hose.
Connect the water draining hose as described in the
operation manual.
No water can be seen in the machine during washing.
This is not a problem. The water level is not
visible from the outside of the machine.
8 Solution suggestions for problems
 previous next