Beko WM 7335 W Cordless Saw User Manual


  Open as PDF
of 36
 
EN
27
The door is jammed.
- Water level might be above the lower level
of the door.
-Machinemightbeheatingupthewateror
it may be at the spinning cycle.
- Due to an electrical mechanism, the door
can only be opened a few minutes after the
programme has stopped.
-Runeitherthe“Pump”or“Spin”programme.
- Wait until the process is over.
- Wait until the process is over.
Machinefillswithwaterwhenaprocessiscancelled.
Inside of machine may be hot.
For safety reasons, water should be cycled in and out a
couple times.
Itcontinuouslyspins.Remainingtimedoesnotcountdown.(Onmodelswithdisplay)
There may be an imbalance of laundry in the
machine.
- The automatic spin correction system might have
been activated due to the unbalanced distribution of the
laundry in the drum.
-Thelaundryinthedrummaybeclustered(bundled
laundryinabag).Laundryshouldberearrangedand
re-spun.
- No spinning is performed when the laundry is not evenly
distributed in the drum to prevent any damage to the
machine and to its environment.
Washing time takes longer than the time specified in the manual
- Water pressure may be low.
- Supply voltage may be low.
- Input temperature of water may be low.
- There may be an imbalance of laundry in
the machine.
- Number of rinses and/or amount of rinse
water might have increased.
- The machine will wait until there is sufficient amount of
water, which will lengthen the washing time to avoid poor
washing results due to insufficient water.
- Washing time is extended to avoid poor washing results
when the supply voltage is low.
- Cycle time is extended to heat up the water when
the input water is cold. Also, washing time can be
lengthened to avoid poor washing results.
- The automatic spin correction system might have
been activated due to the unbalanced distribution of the
laundry in the drum.
-Thelaundryinthedrummaybeclustered(bundled
laundryinabag).
- Laundry should be rearranged and re-spun.
- No spinning is performed when the laundry is not evenly
distributed in the drum to prevent any damage to the
machine and to its environment.
- Water amount is increased to obtain a better rinse and
a rinse cycle is added when necessary.
 previous next