Filter
Top Products
12
USING THE ROUTER WITH DUST EXTRACTION
• When using dust extraction, be sure that the vacuum cleaner is out of the way and secure
so that it will not tip over or interfere with the router or workpiece. The vacuum hose and
power cord must also be positioned so that they don't interfere with the router or
workpiece. If the vacuum cleaner or vacuum hose cannot be positioned properly, it should
be removed.
• Turn on vacuum cleaner before router.
• Empty the vacuum cleaner as necessary.
HINTS FOR OPTIMUM USE
When working on outside edges, move the tool counterclockwise (fig. K). When working on
inside edges, move the tool clockwise.
• Use HSS (high speed steel) router bits for softwood.
• Use TCT (tungsten carbide tipped) router bits for hardwood.
• You can use the tool without a guide (fig. L). This is useful for sign writing and creative
work. Only make shallow cuts.
• Refer to the table below for common types of router bits.
ROUTER BITS (FIG. M) (NOT INCLUDED)
• Do not use router bits with a diameter greater than 1-5/8” (41mm). Use of larger than
recommended bits can result in a hazard.
Description
Application
Straight bit (1) Grooves and rabbets
Trimming bit (2) Trimming laminates or hardwood; accurate profiling using a
template
Rabbiting bit (3) Rabbets on straight or curved workpieces
V-grooving bit (4) Grooves, engraving and edge beveling
Core box bit (5) Fluting, engraving and decorative edge moulding
Cove bit (6) Decorative edge moulding
Ogee moulding bit (7) Decorative edge moulding
Rounding over bit (8) Rounding over edges
Dovetail bit (9) Dovetail joints
Chamfer bit (10) Chamfer edges
Troubleshooting
Problem Possible
Cause Possible
Solution
• Unit will not start. • Cord not plugged in. • Plug in cord.
• Circuit fuse is blown. • Replace circuit
fuse.
• Circuit breaker is tripped. • Reset circuit
breaker.
• Cord or switch is damaged. • Have cord or
switch replaced
at Black &Decker
Service Center or
Authorized
Servicer
For assistance with your product, visit our website www.black&decker.com for the
location of the service center nearest you or call the BLACK & DECKER help line at
1-800-544-6986.
MAINTENANCE
Your tool has been designed to operate over a long period of time with a minimum of
maintenance. Continuous satisfactory operation depends upon proper tool care and
regular cleaning.
WARNING: To prevent personal injury, always disconnect plug from power source
before performing any maintenance. Failure to do so could result in accidental
starting and possible injury.
492777-00 FS1200RP Router 2/6/06 1:02 PM Page 12