Black & Decker BDPS600K Paint Sprayer User Manual


 
Q2
Unplug the sprayer from the power source.
Remove the tubing from the intake and return ports (figure Q2).
Hold the tubing over the waste container and let any remaining liquid in the
hose drain out.
REASSEMBLY
Slide the spring onto the front of the piston
(figure R).
Insert the piston and spring into the front
housing (figure R1).
Pressing down on the release button, insert
the front housing with piston, into the sprayer
until the release button pops into place
(figure R2).
NOTICE: The unit will not reassemble with-
out the piston and spring in place.
Place a few drops of oil through the cylinder
opening. Insert the atomizer valve into the front
housing. Thread the spray nozzle onto the front
housing and hand tighten (figure R3).
Using the oil lubricant provided, place a few
drops of oil down the intake and return openings
of the sprayer as shown in figure R4.
Rotate the quick clean lever from paint to
clean and back 3 times after oiling.
Insert the pickup tube into the intake opening
on the sprayer (figure R5).
R1
R2
R3
R
R4
15
R5