Filter
Top Products
-19-
DUST EXTRACTION HOOD FOR
BACKSIDE OF FIXED BASE
Read and understand these
instructions and tool
manual for use of these accessories.
Do not reach in area of the bit while the
r
outer is ON or plugged in.
To avoid entangling hoses,
do not use this dust
extraction hood at the same time as any
other dust extraction hood.
This dust extraction hood is designed for use
with Bosch routers 1617, 1617EVS, 1618,
1618EVS and their fixed bases when the
routing is done in the middle of the workpiece,
such as when creating slots or routing out
patterns for inlays.
To attach the hood to the router base, slide
the hood into the backside of the router base
around the router’s depth adjustment rod with
the hood’s rounded corners facing up (Fig. 1
& 2). Securely tighten the two knurled
thumbscrews.
The dust extraction hood itself is sized to
accept 35mm vacuum hoses. Also included is
the VAC002 adapter that will connect the
hood to 1-1/4’’ and 1-1/2’’ vacuum hoses.
An adapter to connect the hood to 2-1/2"
hoses is also available, (optional accessory
VAC 020).
USING THE HOOD FOR BACKSIDE OF
FIXED BASE
For maximum dust collection effectiveness,
make sure the router’s chip shield is in place.
!
WARNING
!
CAUTION
DUST
EXTRACTION
HOOD
ROUTER
BASE
M5 SCREW
FIG. 22
FIG. 23
BM 2610925542 07-06.qxp 7/24/06 12:06 PM Page 19