Filter
Top Products
SIDE HANDLE
The side handle used to guide and balance
the tool can be threaded into the front
housing on either side, and on top of the tool,
depending on personal preference and
comfort. Use the side handle for safe control
and ease of operation.
CUP GRINDING WHEELS
Use cup grinding wheels for heavy-duty
stock removal of metals, concrete and
stone.
ADJUSTABLE CUP
WHEEL GUARD INSTALLATION
Open the guard clamp and fit it on the
mounting flange then secure by tightening
the clamp screw. ALWAYS HAVE THIS
GUARD ATTACHED WHEN USING CUP
GRINDING WHEELS
The adjustable guard allows you to lower or
raise the guard’s shell. TO ADJUST: Loosen
the four bolts on the shell, and secure the
shell for 1/4” wheel exposure for maximum
safety.
ATTACHING CUP GRINDING WHEEL
Thread the cup grinding wheel on the
spindle shaft CLOCKWISE. Press in the
spindle lock button and turn the cup grinding
wheel until the lock button engages, then
tighten the wheel securely by hand.
TO REMOVE: Reverse procedure.
-8-
Operating Instructions
"TRI-CONTROL" PADDLE SWITCH
The “Tri-Control” Paddle Switch enables the
operator to control the switch functions of
"Lock-OFF", "ON/OFF" and "Lock-ON".
TO UNLOCK SWITCH
AND TURN TOOL
"ON": Push paddle
lever FORWARD
(toward the spindle)
then squeeze the
paddle lever.
TO SWITCH TOOL "OFF": Release pressure
on paddle lever. The switch is spring loaded
and will return to "OFF" position
automatically.
The "Lock-ON" feature, incorporated into
the paddle switch, is a convenience for long
operations.
TO LOCK SWITCH "ON": After paddle
switch has been activated push paddle lever
completely FORWARD and release paddle
lever.
TO SWITCH TOOL "OFF": Squeeze and then
release paddle lever. The switch is spring
loaded and will return to "OFF" position
automatically.
Hold the tool with both
hands while starting the
tool, since torque from the motor can cause
the tool to twist.
Start the tool before applying to work and let
the tool come to full speed before contacting
the workpiece. Lift the tool from the work
before releasing the switch. DO NOT turn the
switch “ON” and “OFF” while the tool is
under load; this will greatly decrease the
switch life.
!
WARNING
0
1
BOLT
ADJUSTABLE
GUARD
CUP
GRINDING
WHEEL
SHELL
SPINDLE
MOUNTING
FLANGE
BM 1609929A20 3/03 3/12/03 10:35 AM Page 8