Filter
Top Products
-15-
39DBC<4=CB
742:8=6!45CJ
4E4;(C>?
1. Lower head assembly and engage head assem-
bly lock pin.
2. Slide head assembly completely to the back and
tighten the rail lock knob.
3. Rotate table to the 0° miter position.
4. Pull up bevel lock lever to unlock bevel.
5. Move bevel range selector knob to 45°-0° posi-
tion. (See page 28)
6. Tilt the saw assembly to the left, then rotate saw
assembly to the right until you feel the stop in the
45° left position. This is where the saw is cur-
rently set for the 45° left bevel cut.
7. Use the head (remove ruler) of a combination
square to check blade at the 45° stop. Place the
combination square head on the table and press
it’s 45° surface against the blade. If the blade
does not contact the full length of the square,
(figure 8a), follow the calibrating procedure.
0;81A0C8=6!45CJ
4E4;(C>?
1. Remove rear cover to expose bolts.
2. Lift bevel lock lever to release bevel lock.
3. Tilt saw to 45° left bevel position.
4. Remove the ruler from the combination square
and position with 45° surface against blade.
(Figure 8a)
5. Place 10mm open-end wrench on bolt head “F”.
While rotating bolt “F”, watch blade tilt move-
ment until it is aligned with the 45° surface on
combination square. (Figure 8b)
6. Adjust bevel pointer to 45° line on bevel scale.
)01;4
;034
><18=0C8>=
(@D0A4
4E4;!>2:
!4E4A
86DA40!45CJ4E4;(C>?
86DA41!45CJ4E4;39DBC<4=C
39DBC8=64E4;!>2:!4E4A)4=B8>=
1. Lift bevel lock lever to release bevel lock.
2. Place 17mm open-end flat wrench on bolt head
“E” (Figure 8b).
3. Turn nut “E” clockwise 1/8 turn to tighten bevel
lock tension or turn counter-clockwise to 1/8 turn
to loosen bevel lock tension.
4. Push down bevel lock lever until you feel the lever
snap into the locked position.
5. Verify that bevel lock tension holds the bevel po-
sition secure and also allows bevel lock lever to
lock down to the point that a solid stop is felt.
6. If necessary, repeat steps 1–5 to adjust the ten-
sion.
BM 2610012089 03-10 E:BM 2610012089 03-10 E 3/30/10 7:40 AM Page 15