Filter
Top Products
10.
Nail Unloading
Always disconnect tool from air supply
before removing nails from magazine.
This avoids the risk of unintentional operation.
Do not disconnect air hose from the tool
with finger on trigger or work contact
element depressed. The tool can fire when reconnected to
air supply.
1.Disconnect air supply.
2.Push magazine latch and pull magazine to open position,
see figure 3.
3.Grasp the rear of the nail strip and remove from
magazine.
Depth of Drive Adjustment
The depth with which nails are driven into the work piece
can be adjusted using the depth adjustment on the nose of
the tool, figure 10.
Disconnect the tool from the air source
before making adjustments. Such
precautionary safety measures reduce the risk or
unintentional tool operation.
1.Disconnect tool from air supply.
2.Remove nails from tool as described in the “Nail
Unloading” section of this manual.
3.Adjust tool driving depth:
• To reduce the nail depth, turn the adjustment knob
counter clockwise, see figure 11.
• To drive the nail deeper, turn the adjustment knob
clockwise, see figure 12.
4.Reload nails as described in the “Nail Loading” section of
this manual.
5.Reconnect air supply
Know what is behind your work piece.
Do not fire nails into walls or floors
without assuring the area on the opposite side is clear.
A nail could travel through the work piece, striking someone.
Operation
FlushToo Deep
Turn the adjustment knob counter clockwise.
Turn the adjustment knob clockwise.
Too Shallow
Flush
FIG. 11
FIG. 12
!
WARNING
!
WARNING
!
WARNING
!
WARNING
Depth
Adjustment
Knob
Work Contact
Element
FIG. 10
BM 2610957386 04-09:BM BNS200-18 04-09 6/17/09 7:55 AM Page 10