Filter
Top Products
-10-
Accessory Material Application
Selecting Accessories
BIM segment
saw blade
HCS plunge
cut saw
blade
BIM plunge
cut saw
blade
HM-Riff
Segmented
saw blade
Rigid scraper
Flexible
scraper
Base plate
for sanding
H
ard and soft wood,
p
lastic, non-ferrous
metals
Wooden materials,
plastic, gypsum and
other soft materials
Hard and soft wood,
metal (e.g., nails,
screws, small profiles),
non ferrous metals
Grouting joints, soft
wall tiles, glass-fibre
reinforced plastic and
other abrasive
materials
Wooden materials,
plastic, gypsum and
other soft materials
Silicone and other
elastic materials
Depends on sanding
sheet
Separating and plunge cuts; also for
sawing close to edges, in corners and
hard to reach areas;
Example: shortening already installed
bottom rails or door hinges, plunge
cuts for adjusting floor panels.
Separating and deep plunge cuts; also
for sawing close to edges, in corners
and hard to reach areas;
Example: Sawing off water pipes
(PVC) or cable ducts flush against
walls, floors or ceilings.
Smaller separating and plunge cuts;
Example: Shortening narrow profiles,
cutting fastening elements such as
staples and nails.
Cutting and separating close to edges,
in corners or hard to reach areas;
Example: Removing grouting joints
between wall tiles for repair work,
cutting openings in tiles, gypsum
boards or plastic.
Scraping off old coats of varnish or
other adhesive, removing bonded
carpeting, e.g., on stairs/steps or other
small/medium-sized surfaces.
Removal of putty or other softer
residue from confined areas.
Sanding surfaces close to edges, in
corners or hard to reach areas;
Depending on the sanding sheet for,
e.g., sanding wood, paint, varnish,
stone, glass.
Optional Accessories
BM 2609140575 07-08 7/8/08 3:54 PM Page 10