Filter
Top Products
Step 4
While keeping the Zip Bit in contact with the
outside of the box move the tool counter
clockwise while applying light inward and
upward pressure until you feel and hear it
come to the corner. As you round the corner
apply light pressure left and downward.
Step 5
While moving slowly and continuously along
the top contour you will feel the Zip Bit come
to the next corner. Round the corner and
apply light down and inward pressure until
the bottom corner is reached.
-12-
Step 2
Slide switch to turn the tool on. While holding
the Spiral Saw power tool firmly with both
hands plunge the Zip Bit through the mark
you made. Then guide the Zip Bit to the right
until you feel and hear the Zip Bit touch the
inside edge of the box.
Step 3
Pull the Zip Bit out far enough to slip it over
the edge of the box so it is now against the
outside of the box.
RZ 2610917368 9-04 10/1/04 8:09 AM Page 12