6
Operating Instructions and Parts Manual
www.chpower.com
Figure 4
The DANGER, WARNING, CAUTION, and NOTICE notifications and
instructions in this manual cannot cover all possible conditions and
situations that may occur. It must be understood by the operator that
common sense and caution are factors which cannot be built into this
product, but must be supplied by the operator.
Important Safety Information (Continued)
Do not place tool on pre-finished flooring in an
abusive manner. Careless placement of the tool may mar or damage the
flooring.
Always use the rubber end of the mallet only for striking the rubber
bumper. Damage to the tool may occur if you use the metal end. The
metal end is only to be used for racking the flooring boards.
Avoid using the nailer when the magazine is empty. Accelerated
wear on the nailer may occur.
SERVICE
a.
Tool service must be performed only by qualified repair personnel.
b.
When servicing a tool, use only identical replacement parts. Use only authorized
parts.
c.
Use only the lubricants supplied with the tool or specified by the manufacturer.
AIR SOURCE
a.
Never connect to an air source that is capable of exceeding 200 psi. Over
pressurizing the tool is able to result in bursting, abnormal operation, breakage of
the tool or serious injury to persons. Use only clean, dry, regulated compressed air at
the rated pressure or within the rated pressure range as marked on the tool. Always
verify prior to using the tool that the air source has been adjusted to the rated air
pressure or within the rated air-pressure range.
b.
Never use oxygen, carbon dioxide, combustible gases or any bottled gas as an
air source for the tool. Such gases are capable of explosion and serious injury to
persons.
Air compressors providing air to the nailer should follow the
requirements established by the American National Standards Institute
Standard B19.3-1991; Safety Standard for Compressors for Process Industries. Contact your air
compressor manufacturer for information.
Read all flooring manufacturer warnings, procedures, and instructions
before using this tool. The information provided by the flooring
manufacturer must be followed.
SAVE THESE INSTRUCTIONS
DO NOT DISCARD
Figure 2
Figure 3 - Do not carry the nailer by the
air hose