Filter
Top Products
Operation
-16- Legend™ 1200E Spot User Manual Rev. 03c
Continued from previous page
Tilt Reversal
This option reverses the tilt angle assignments from 000 = 0º and 255 = 270º to 000 =
270º and 255 = 0º.
1) Select Tilt Inverse.
2) Select Yes (reversed assignments) or No (normal assignments).
3) Press <ENTER>.
Blackout During Head
Motion
This option enables the blackout feature while the fixture head is moving (panning or
tilting).
1) Select Bl.o. P/T Moving.
2) Select Yes (blackout enabled) or No (blackout disabled).
3) Press <ENTER>.
Blackout During Color
Change
This option enables the blackout feature while the fixture is changing colors.
1) Select Bl.o. Color Change.
2) Select Yes (blackout enabled) or No (blackout disabled).
3) Press <ENTER>.
Auto Focus
This option enables the auto focus feature while the fixture is zooming from narrow to
wide and vice versa.
1) Select Auto Focus.
2) Select Yes (auto focus enabled) or No (autofocus disabled).
3) Press <ENTER>.
Lamp Settings
The Lamp Settings section comprises all the parameters that affect the fixture’s lamp
and its operation. To access this section, do the following:
1) Press <MENU>.
2) Select Lamp Settings.
3) Select the corresponding function as indicated below.
4) Press <MENU> to exit once you are done with this section.
Lamp On/Off
This option allows turning the lamp off and back on without having to power cycle the
fixture.
1) Select On/Off.
2) Select Yes or No.
3) Press <ENTER>.
The lamp will turn on or off after pressing <ENTER>.
Immediate or Delayed
Lamp Strike
This option allows the lamp to strike immediately (Yes) or in delayed mode (No) after
powering on the fixture. Delaying the lamp strike reduces the inrush current.
1) Select State/Power On.
2) Select Yes (immediate) or No (delayed).
3) Press <ENTER>.
The “Ignition Delay” option on page 17 controls the delay between power on and
the lamp striking.
Lamp On/Off Remote
Control
This option allows the lamp to turn the lamp off and back on from the DMX controller.
1) Select Off Via DMX.
2) Select Yes or No
3) Press <ENTER>.
Lamp On When DMX is
Present
When enabled (Yes), this option turns the lamp on when DMX signal is present.
1) Select On if DMX On.
2) Select Yes or No
3) Press <ENTER>.
Continues on the next page