Filter
Top Products
Intimidator™ Spot 150 User Manual 17 6/19/2009 9:08 AM
User Configurations
TO SET THE PAN TO INVERTING OR NON-INVERTING:
1) Press the <MENU/ESC>.
2) Select the desired option by using the <UP> and/or <DOWN> button to navigate through the
display until you reach “3-Pan”.
2) Press the <ENTER> button.
Note: you may select “Normal” using the <UP and/or <DOWN buttons and press the <ENTER>
button for non-inverting; or, you may select “Reverse” for inverting.
TO SET THE TILT TO INVERTING OR NON-INVERTING:
1) Press the <MENU/ESC>.
2) Select the desired option by using the <UP> and/or <DOWN> button to navigate through the
display until you reach “4-Tilt”.
2) Press the <ENTER> button.
Note: you may select “Normal” using the <UP> and/or <DOWN> buttons and press the <ENTER>
button for non-inverting; or, you may select “Reverse” for inverting.
TO ACTIVATE/DEACTIVATE MOVE-IN-BLACK FUNCTION(S):
This fixture has a built-in function that will offer greater ease in programming. This is called the move-
in-black function. This is the option of stating that the fixture will blackout (close shutter) between 2
different steps of operation via DMX. You may enable and disable this function remotely via the
control channel in DMX operation. See the below instructions for this operation for the pan/tilt
movement.
1. Using a DMX controller, bring channel 14 (in advanced mode) to a value of [010014].
2. Hold this value for 3 seconds.
3. After 3 seconds, you may bring the channel back down to a value of [000].
4. The fixture now has saved this setting in the onboard memory and will retain it. If you wish
to disable this function, then you may bring channel 14 to a value of [015019].
You may follow the above steps for the pan/tilt, color, gobo, and combined movement by locating the corresponding DMX
values in the DMX values section of this user manual.
Additional Functions
TO USE THE FIXTURE WITH THE CA-9 EASY CONTROLLER.
1) Under the “Run” option in the menu, select “Econtr”.
2) Press the <ENTER> button.
3) Now, plug in the CA-9 into the EASY CONTROLLER connection on the back panel of the fixture.
RESETTING THE FIXTURE:
1) Under the “10-Reset system”, Press <ENTER>.
2) “Select: Ok”.