Filter
Top Products
4. Operating Instructions 10 1/7/2011 4:34 PM
Master/Slave Mode (Sound-Active, Automatic)
This mode allows a single unit, the master, to operate in either automatic or sound-active mode.
When additional (slave) fixtures are daisy chained to the master, they will all synchronize with
the master and run the same lighting show.
Please see the instructions below for details on this mode.
Master:
1. Place the master fixture first in the daisy chain.
2. Set the master fixture to operate in either automatic or sound-active mode; please see
the appropriate sections of this manual for details on this procedure.
Slave:
1. Daisy chain from the output of the master fixture.
2. Press <MODE> until 512 appears on the LED screen.
3. Press <ENTER>.
4. Using <UP> & <DOWN>, set the DMX starting address to 001.
5. Press <ENTER>.
Only connect 31 slave fixtures when operating in this mode!
When the fixture is in slave mode, the red DMX and the yellow SLAVE LED will illuminate.
Standalone
Sound-Active
Please see the instructions below for details on this mode.
1. Plug the fixture into power.
2. Press <MODE> until SNd appears on the LED screen.
3. Press <ENTER>.
4. Use the microphone sensitivity adjustment knob to adjust the fixture to react to the
beat of the music.
5. Press <ENTER>.
When the fixture is in sound-active mode, the green SOUND LED will illuminate.
The microphone will only respond to low frequencies (bass).
Automatic
Please see the instructions below for details on this mode.
1. Plug the fixture into power.
2. Press <MODE> until AUTO appears on the LED screen.
3. Press <ENTER>.
4. Using <UP> & <DOWN>, adjust the program speed (S_ _1~S100) (fast~slow).
5. Press <ENTER>.
When the fixture is in automatic mode, the blue AUTO LED will illuminate.