Filter
Top Products
4. Operating Instructions 9 1/7/2011 4:34 PM
Operation
DMX Operation
This operating mode will allow for control with an external DMX controller. You must set the
starting address for this mode.
If this is your first time using DMX, then it is recommended that you refer to the “DMX Primer”
section in the “Appendix” of this manual.
Please see the instructions below for details on this mode.
1. Plug the fixture into power.
2. Plug a DMX controller into the fixture in a daisy chain configuration.
3. Press <MODE> until 512 appears on the LED screen.
4. Press <ENTER>.
5. Using <UP> & <DOWN>, select the DMX starting address.
6. Press
<ENTER>
.
When the fixture is in DMX mode, the red DMX LED will illuminate.
When the fixture is in DMX mode and addressed to A001, the yellow SLAVE LED will
illuminate. This is normal.
DMX Channel Values
C
HANNEL
V
ALUE
F
UNCTION
1
000 ó 009
010 ó 014
015 ó 019
020 ó 024
025 ó 029
030 ó 034
035 ó 039
040 ó 044
045 ó 049
050 ó 054
055 ó 059
060 ó 064
065 ó 069
070 ó 074
075 ó 079
080 ó 139
140 ó 199
200 ó 249
250 ó 255
Color/Mode
Blackout
Red
Green
Blue
Amber
Green + blue
Red + blue
Red + green
Red + amber
Green + amber
Blue + amber
Red + green + blue
Green + blue + amber
Red + blue + amber
Red + green + blue + amber
Automatic (single colors only)
Automatic (two colors at a time)
Automatic
Sound-active
2
160 ó 255
Automatic Speed (when CH1 is between 094~255)
Slow ó fast
3
000 ó 004
005
ó
255
Strobe
No Function
Strobe (slow
ó
fast) (max 30 Hz)
4
000 ó 004
005 ó 127
128 ó 133
134
ó
255
Motor Rotation
Stop
Rotate clockwise
Stop
Rotate counter-clockwise