Chauvet QSPOT Work Light User Manual


 
Q-Spot™ 150-LED User Manual 20 9/22/2009 3:57 PM
Q-Spot™ 150-LED Troubleshooting
Symptom
Solution(s)
Beam is very dim or not
bright
Clean optical SYSTEM
Breaker/Fuse keeps
blowing
Check total load placed on device
Device has no power
Check for power on Mains.
Check device’s fuse. (internal and/or external)
Fixture is not responding
Check DMX Dip switch settings for correct
addressing
Check DMX cables
Check polarity switch settings
Fixture is on but there is
no movement to the audio
Make sure you have the correct audio mode on the
control switches.
Loss of signal
Use only DMX cables
Install terminator
Note: Keep DMX cables separated from power
cables or black lights.
Moves slow
Check 220/110v switch for proper setting
No light output
Call service technician
Stand alone mode
This fixture contains standalone programs. Please
see the appropriate section(s) for the details of
operation
If you still have a problem after trying the above solutions, please contact CHAUVET Technical
Support at the location on the next page.
Technical Support
Address: Service Dept.
3000 N 29th Ct, Hollywood, FL 33020 (U.S.A.)
Support (Email): tech@chauvetlighting.com
Telephone: (954) 929-1115 - (Press 4)
Fax: (954) 929-5560 - (Attention: Service)
Website: http://www.chauvetlighting.com