Filter
Top Products
SKU 45690 PAGE 4
5. DO NOT FORCE THE EQUIPMENT. This Spot Welder will do the work better and
safer at the speed and capacity for which it was designed.
6. AVOID UNINTENTIONAL STARTING. Make sure you are prepared to begin work
before turning the Control Switch (part #25) “ON”.
7. Caution: Never touch the Upper and Lower Tongs (parts #46, #47) when welding a
workpiece. Allow the Tong Tips (part #48) and the workpiece to cool before handling.
(See Figures A, B, E, and Assy. Diagram.)
8. MAKE SURE THE WORKPIECE IS SECURED AT ALL TIMES DURING OPERATION.
Use a vise, clamps, etcetera (not provided).
9. OVERUSE CAN CAUSE OVERHEATING. After continuous use, allow the Spot
Welder adequate time to cool before the next use.
10. BEFORE TRYING NEW OR COMPLICATED TECHNIQUES, STUDY THE
PROCEDURE, AND PRACTICE WITH SCRAP METAL.
11. ALWAYS DISCONNECT THE SPOT WELDER FROM ITS ELECTRICAL
SUPPLY SOURCE BEFORE ASSEMLING, PERFORMING ANY SERVICES OR
MAINTENANCE always disconnect the electrical cord before leaving the work area,
moving the tool from one location to another, handing the tool to another person,
changing Tong Tips (part #48), cleaning the unit, etcetera.
12. WARNING: This product, when used for welding and similar applications, produces
chemicals known to the State of California to cause cancer and birth defects (or other
reproductive harm). (California Health & Safety Code 25249.5 et seq.)
13. WARNING: Operation of equipment in close proximity to a heart pacemaker could
cause interference or failure of the pacemaker.
REV 04e