Filter
Top Products
10. Re-tighten the four Cap Screws (parts #3, #11).
BOTTOM TONG
CLAMP (#35)
TOP TONG
CLAMP (#13)
TOP TONG
HOLDER (#12)
TONG
INSULATOR
(#33)
TONGTIP
(#48)
LOWER
TONG
(#47)
UPPER
TONG
(#46)
CAP
SCREW
(#34)
HEX JAM NUT (#10)
HEX JAM NUT (#10)
HEX NUT (#20)
OPERATING
LEVER
(#5)
CAP
SCREW
(#3)
FIGURE A
TONG ALIGNMENT
UPPER TONG (#46)
TONG TIPS (#48)
LOWER TONG (#47)
UPPER TONG (#46)
LOWER TONG (#47)
TONG TIPS (#48)
FIGURE B
To Attach The Handle To The Spot Welder:
1. To attach the Wooden Handle (part #17) to the Spot Welder, insert the Bolt (part
#19) through the following parts in this order: through a Handle Bracket (part #18),
through the Wooden Handle, and through the remaining Handle Bracket. Then,
secure the parts together, using the Lock Washer (part #49) and Hex Nut (part #20).
(See Figure C, and Assy. Diagram.)
SKU 45690 PAGE 6