Filter
Top Products
SKU 65834 For technical questions, please call 1-800-444-3353. Page 6
least the minimum wire size required.
(See Table A.)
If you are using one extension cord 5.
for more than one tool, add the
nameplate amperes and use the sum
to determine the required minimum
cord size. (See Table A.)
Make sure the extension cord is prop-6.
erly wired and in good electrical con-
dition. Always replace a damaged
extension cord or have it repaired by
a qualied electrician before using.
RECOMMENDED MINIMUM WIRE
GAUGE FOR EXTENSION CORDS*
(120 VOLT)
NAMEPLATE
AMPERES
(at full load)
EXTENSION CORD
LENGTH
25’
50’
75’
100’
150’
0 – 2.0 18 18 18 18 16
2.1 – 3.4 18 18 18 16 14
3.5 – 5.0 18 18 16 14 12
5.1 – 7.0 18 16 14 12 12
7.1 – 12.0 18 14 12 10 -
12.1 – 16.0 14 12 10 - -
16.1 – 20.0 12 10 - - -
TABLE A
* Based on limiting the line
voltage drop to ve volts at
150% of the rated amperes.
PRODUCT SPECIFICATIONS
Electrical
Requirements
120 VAC / 60 Hz
Power Cord: 18 AWG x 3C SVT
Power Plug: 3-Prong, Non-Polarized
Output Voltage: 14.4VDC Maximum
Output Current: 6 Amps Maximum
Product
Applications
6VDC or 12VDC Lead-Acid Batteries Only.
(3Ah to 48Ah Charger Capacity)
Indoor Use Only
Features
Three Error Codes Display:
“E01” = Wrong Polarity
“E02” = Disconnected During Charging
“E03” = Damaged Battery or
Not a 6V or 12V Battery
Battery Status Display:
Empty = No Battery/No Connection
One Bar = Battery Connected
Four Bars = Fully Charged
Flashing Bars = Battery Charging
4-Stage Charging Symbol Indicates
2 Amp, 4 Amp, 6 Amp, or Auto
Push Button Starts Charging
Display Shows Charging Voltage
Accessories Battery Cable Clamps (Qty. 2)
UNPACKING
When unpacking, check to make sure
that the item is intact and undamaged. If
any parts are missing or broken, please
call Harbor Freight Tools at the number
shown on the cover of this manual as soon
as possible.
OPERATING INSTRUCTIONS
Read the ENTIRE IMPORTANT
SAFETY INFORMATION section
at the beginning of this manual
before set up or use of this
product.
TO PREVENT
SERIOUS INJURY FROM ACCIDENTAL
OPERATION:
Unplug the Battery Charger from its
power source before performing any
inspection, maintenance, or cleaning
procedures.
SYMBOLOGY
Double Insulated
Canadian Standards Association
Underwriters Laboratories, Inc.
V~
Volts Alternating Current
A
Amperes
n
0
xxxx/min.
No Load Revolutions per Minute
(RPM)