Filter
Top Products
SKU 65834 For technical questions, please call 1-800-444-3353. Page 8
If the battery 3. is not 6 volt or 12 volt,
or the battery is damaged, the LCD
will display “E03”. (See Below.)
Battery Status
If the battery 1. is not connected, the
LCD will display the following:
(See Below.)
If the battery 2. is connected, the LCD
will display the following:
(See Below.)
If the battery 3. is fully charged, the LCD
will display the following:
(See next illustration.)
If the battery is in the process of 4.
charging, the LCD will display the fol-
lowing: (See Below.)
Sound Alarms:
A 1. continuous “beep” indicates wrong
polarity, disconnection during charg-
ing, wrong type of battery, dead or
improper battery connection.
A 2. short “beep” occurs each time a
button is pressed.
A 3. short “beep” occurs when connect-
ing or disconnecting the battery.
The Charging Process:
Remove the battery caps from the 1.
vehicle’s battery to allow any excess
gas to escape and prevent bursting of
the battery.
Check and top off the battery’s liquid.2.
When the battery being charged is in 3.
the vehicle, verify that the ignition is
off. Connect the positive
(RED with +) Battery Clamp to the