Filter
Top Products
SKU 65834 For technical questions, please call 1-800-444-3353. Page 9
positive (+ or P) terminal of the bat-
tery. Connect the negative (BLACK
with --) Battery Clamp to an unpaint-
ed, solid metal portion of the vehicle.
Do not connect to the carburetor or
fuel lines.
After the Battery Clamps are con-4.
nected, slightly rotate the Clamps to
remove any dirt or oxidation layer to
ensure proper contact.
Plug the Power Cord of the Battery 5.
Charger into the nearest 120 volt,
grounded, electrical outlet.
To select the charging speed: Press 6.
the “AMPS SELECTION” button for
maximum charging current.
(See Figure A and Below.)
Recommended Charging Current
Charging
Current
2 Amp 4 Amp 6 Amp
Battery
Capacity
3 ~ 20 Ah 6 ~ 36 Ah 12 ~ 48 Ah
To select the battery voltage: Press 7.
the “BATTERY SELECTION” button
(either 6V or 12V). (See Figure A.)
To start the charging process: Press 8.
the “ON/OFF” Power Switch. There
is a short “beep” sound to indicate the
charging has started.
(See Figure A.)
The Charging Stages:
The constant charging stage: Press 1.
the “ON/OFF” Power Switch. The
Battery Charger will run under the
charging current selected until the
charging voltage is raised up to 7.2
volts for a 6 volt battery or up to 14.4
volts for a 12 volt battery. The Bat-
tery Charger will then turn to the next
charging stage under constant volt-
age.
If “AUTO” is selected, the Battery
Charger starts charging from 2 Amps
until the charging voltage is raised up
to 7.2V volts for a 6 volt battery (mo-
torcycle) or up to 14.4V volts for a 12
volt battery (automobile). The Battery
Charger then turns to the next charg-
ing stage (oat charging).
Constant voltage stage: The Battery 2.
Charger outputs a constant charging
voltage of 7.2 volts for a 6 volt battery
or 14.4 volts for a 12 volt battery. The
charging current gradually decreases
until it is less than 1 Amp and turns to
the next oating charging stage.
Floating charging stage: The battery 3.
is fully charged and ready to use.
The LCD Display shows the battery
signal which indicates the battery is
fully charged. The Battery Charger
outputs a constant safe voltage of 6.8
volts for a 6 volt battery or 13.6 volts
for a 12 volt battery for oating charg-
ing.
Disconnecting the Battery
Charger and Battery:
Once the battery is fully charged, dis-1.
connect the Power Cord of the Bat-
tery Charger from its electrical outlet.
Disconnect the negative (BLACK 2.
with --) Battery Clamp from its un-
painted, solid metal portion of the
vehicle. Then disconnect the positive
(RED with +) Cable Clamp (7) from
the positive (+ or P) terminal of the
battery.