Filter
Top Products
SKU 66718 For technical questions, please call 1-800-444-3353. Page 7
The smaller the gauge number of the 3.
wire, the greater the capacity of the
cord. For example, a 14 gauge cord
can carry a higher current than a 16
gauge cord. (See Table A.)
When using more than one exten-4.
sion cord to make up the total length,
make sure each cord contains at
(See Table A.)
If you are using one extension cord 5.
for more than one tool, add the
nameplate amperes and use the sum
to determine the required minimum
(See Table A.)
If you are using an extension cord 6.
outdoors, make sure it is marked with
indicate it is acceptable for outdoor
use.
Make sure the extension cord is prop-7.
erly wired and in good electrical con-
dition. Always replace a damaged
extension cord or have it repaired by
Protect the extension cords from 8.
damp or wet areas.
SYMBOLOGY
Double Insulated
Canadian Standards Association
Underwriters Laboratories, Inc.
V~
Volts Alternating Current
A
Amperes
n
0
No Load Revolutions per Minute
(RPM)
SPECIFICATIONS
Input Power
Output Power
Designed for use only with 4.8, 7.2, 9.6,
12, 14.4, and 18 volt NiMH or NiCd
rechargeable batteries.
Charger
Auto Shut-Off
No. (Care must be taken not to overcharge
batteries)
Polarity
Protection
Yes. (Designed with non-polarity
technology)
Charging Time
capacity)
L.E.D.
Functions
Red = “Charging”
Green = “Fully Charged”
Reset Button
Function
When pressed, Charger will return to
“charge” mode within 2 seconds
Accessories
Charger (Qty. 1)
Charger Input Cord (Qty. 1)
Charger Output Clips (Qty. 1 set)
Charger Output Magnets (Qty. 1 set)
UNPACKING
When unpacking, make sure that the
item is intact and undamaged. If any parts
are missing or broken, please call Harbor
RECOMMENDED MINIMUM WIRE
GAUGE FOR EXTENSION CORDS*
(120/240 VOLT)
NAMEPLATE
AMPERES
(at full load)
EXTENSION CORD
LENGTH
25’
50’
75’
100’
150’
0 – 2.0 18 18 18 18 16
2.1 – 3.4 18 18 18 16 14
3.5 – 5.0 18 18 16 14 12
5.1 – 7.0 18 16 14 12 12
7.1 – 12.0 18 14 12 10 -
12.1 – 16.0 14 12 10 - -
16.1 – 20.0 12 10 - - -
TABLE A
* Based on limiting the line
voltage drop to ve volts at
150% of the rated amperes.