Filter
Top Products
Page 10
SKU 94626 For technical questions, please call 1-800-444-3353
Controls
Making Flush Cuts
1. Place the Saw where the flush cut is to be made. See photo below.
When making a cut under a toe-kick (i.e., under a cabinet), insert the Saw at an angle,
then lower it to the floor surface. See illustrations on the next page.
2. Plug the Power Cord (54) into the electrical outlet.
3. Grab the Forward Handle with your left hand.
4. Grab the Rear Handle with your right hand.
5. To begin cutting, press in (and hold) the Safety Button with your thumb, and at the
same time, pull the Trigger Switch (49) with your index finger.
When the Motor starts turning, release the Safety Button. As the Motor reaches full
speed, begin to move the Saw slowly forward and away from your body to complete
the cut. If a loud grinding noise is heard, the Saw Blade is contacting the cement
foundation. Immediately raise the Saw Blade.
6. When the flush cut is complete, release the Trigger and hold the Saw in place until the
Saw Blade comes to a complete stop. Unplug the Power Cord (54) from the electrical
outlet.
Trigger Switch (49)
Safety Button
Spindle Shaft Lock (33)