Filter
Top Products
Page 9
SKU 94626 For technical questions, please call 1-800-444-3353
Table A
RECOMMENDED MINIMUM WIRE GAUGE FOR EXTENSION CORDS*
(120 VOLT)
NAMEPLATE
AMPERES
(At Full Load)
EXTENSION CORD LENGTH
25
Feet
50
Feet
75
Feet
100
Feet
150
Feet
0 – 2.0 18 18 18 18 16
2.1 – 3.4 18 18 18 16 14
3.5 – 5.0 18 18 16 14 12
5.1 – 7.0 18 16 14 12 12
7.1 – 12.0 16 14 12 10 -
12.1 – 16.0 14 12 10 - -
16.1 – 20.0 12 10 - - -
* Based on limiting the line voltage drop to five volts at 150% of the rated amperes.
SYMBOLOGY
Table B
UNPACKING
When unpacking, check to make sure that all the parts are included. The unit comes fully
assembled. Refer to the Assembly section, and the Assembly Drawing and Parts List at the
end of this manual. If any parts are missing or broken, please call Harbor Freight Tools at
the number on the cover of this manual as soon as possible.
OPERATING INSTRUCTIONS
The Flush Cut Saw is used to cut flooring, or in other areas that need to be cut flush against
a vertical surface (at a toe-kick area or where a wall meets the floor or countertop). The
following steps give you guidelines on using the Flush Cut Saw.
(1)