Filter
Top Products
SKU 94882 PAGE 11
OPERATING INSTRUCTIONS
IMPORTANT - READ BEFORE USE
This Breaker Hammer may have decreased performance for a brief period at the begin-
ning of each use. This warm-up period lasts approximately 3-5 minutes. This happens
because the grease inside the tool may be thick, preventing the tool from operating at
full efficiency while the motor is cold. This is normal and does not indicate a problem. To
help reduce this effect, store this equipment in temperatures no lower than 50-60° F.
How to turn on the Breaker Hammer
To turn on the Breaker Hammer, flip the Switch (62) shown below in Figure 3.
How to Adjust the impact level of the Breaker Hammer
The Impact level is adjusted by turning the Knob (117). The numbers on the Knob
indicate the level of impact. Number one is the lowest level, seven is the highest
level. See Figure 4.
How to attach the chisels
Lock Pin 4
Chisel
Figure 4
Figure 2
Figure 3
1. Slide the chisels into the Breaker Hammer with the flat cut-out side facing up and
while the Rod (4) is aligned with the Chisel shank. See figure 2.
2. The Chisel has a flat space on the shaft that must be turned horizontally when it
is inserted. See Figure 2. Pull out on the Pin and rotate it 90° to lock the Chisel in
place. The Chisel should be able to move back and forth after it is locked but should
not come out.
Switch (62)
Knob (117)
REV 12/06