Filter
Top Products
Page 8 For technical questions, please call 1-800-444-3353. SKU 9624
SPECIFICATIONS
Electrical Input 120 V~ / 60 Hz / 4.2 A (Rated)
Motor Speed 2250 RPM (No Load) VSR
Drive 1/4” Hex
Additional
Features
All Ball Bearing Construction
Trigger Lock Switch
Metal Gear Housing
Removable & Adjustable
Depth Collar
1/4” Magnetic Bit Holder
Accessories Phillips Bit (Qty. 4)
Slotted Insert Bit (Qty. 2)
E194601
UNPACKING
When unpacking, make sure that the
item is intact and undamaged. If any parts
are missing or broken, please call Harbor
Freight Tools at 1-800-444-3353 as soon as
possible.
ASSEMBLY INSTRUCTIONS
NOTE: For additional information regarding
the parts listed in the following pages,
refer to the Assembly Diagram near the
end of this manual.
TO PREVENT
SERIOUS INJURY
FROM ACCIDENTAL
OPERATION:
Unplug the Power Cord (43) from
its electrical outlet before adding
any accessories or making any
adjustments to the tool.
To Change Bit Tip Holders:
Pull forward on the Depth Collar (2) and 1.
remove it from the Clutch Housing (5).
(See Figure A.)
Pull the Bit Tip Holder (4) straight out 2.
with pliers if it is difcult to remove.
(See Figure A.)
Push the new Bit Tip Holder (4) into the 3.
Spindle (7) until the shank of the Bit Tip
Holder snaps in place. (See Figure A.)
Replace the Depth Collar (2) onto the 4.
Clutch Housing (5). Make sure to align
the ribs on the inside of the Depth Collar
with the grooves on the outside of the
Clutch Housing before snapping the
Depth Collar in place. (See Figure A.)
FIGURE A
DEPTH COLLAR (2)
CLUTCH
HOUSING
(5)
BIT TIP HOLDER (4)
SPINDLE
(7)
BIT (3)