Filter
Top Products
Page 9For technical questions, please call 1-800-444-3353.SKU 9624
To Change The Bit:
Pull forward on the Depth Collar (2) and 1.
remove it from the Clutch Housing (5).
(See Figure A.)
Pull the Bit (3) straight out with pliers if it 2.
is difcult to remove. (See Figure A.)
Push the new Bit (3) into the Bit Tip 3.
Holder (4) until the shank of the Bit
snaps in place. (See Figure A.)
Replace the Depth Collar (2) onto the 4.
Clutch Housing (5). Align the ribs on
the inside of the Depth Collar with the
grooves on the outside of the Clutch
Housing before snapping the Depth
Collar in place. (See Figure A.)
OPERATING INSTRUCTIONS
To start the Drywall Screwdriver, depress 1.
the Trigger (38). To stop the tool, release
the Trigger. The variable speed Trigger
permits speed control. The farther the
Trigger is depressed, the higher the
speed of the Tool. (See Figure B.)
To lock the Trigger (38) in the “ON” 2.
position for continuous operation,
depress the Trigger and push in on the
Trigger Lock (39). The tool will continue
to run. To turn off the tool, squeeze and
release the Trigger once. Prior to using
the Drywall Screwdriver (each time),
make sure the Trigger Lock mechanism
is working properly. Always release
the Trigger Lock mechanism before
disconnecting the Drywall Screwdriver
from its electrical outlet. Failure to do so
will cause the tool to start immediately
the next time it is plugged in, resulting
in possible injury or property damage.
(See Figure B.)
The Drywall Screwdriver also features a
3.
Forward/Reverse Switch. The Forward/
Reverse Switch is used to reverse
the rotation of the Bit for backing out
screws. To reverse the rotation, turn
off the Drywall Screwdriver and push
the Forward/Reverse Switch to the right
(when viewed from the back of the tool).
To position the Forward/Reverse Switch
for forward operation, turn off the tool
and push the Forward/Reverse Switch to
the left. (See Figure B.)
The Depth Collar (part #2) allows the 4.
operator to increase or decrease the
fastening depth. To seat a screw deeper
in a workpiece, turn the Depth Collar to
the right. To seat a screw higher in a
workpiece, turn the Depth Collar to the
left. (See Figures A and B.)
TRIGGER
(38)
TRIGGER
LOCK (39)
FORWARD/REVERSE
SWITCH
FIGURE B
DEPTH
COLLAR
(2)