Filter
Top Products
SKU 97588 For technical questions, please call 1-800-444-3353. Page 17
b.
as shown in the illustration above.
c. Use a small prying tool (not includ-
ed) to hold the Spring Clips to the
side while you remove the carbon
brushes. Keep track of which
orientation the old carbon brush-
es were in to prevent needless
wear if they will be reinstalled.
If either carbon brush is worn down d.
both car-
bon brushes.
To clean old carbon brushes before e.
reusing them, rub the contact areas
with a pencil eraser.
Hold the spring clips to the side and f.
reinsert the old carbon brushes in
the same orientation to reduce wear.
When installing the carbon brushes, g.
make sure the carbon portions of the
carbon brushes contact the motor
armature, and that the springs face
away from the motor. Also, make
sure the springs operate freely.
h.
Replace the Brush Caps and i.
Screws. Do not overtighten.
Note: New carbon brushes tend to spark
conform to the motor’s armature.
7. WARNING! If the supply cord of
this power tool is damaged, it must
be replaced only by a qualied
service technician.