Filter
Top Products
SKU 97588 For technical questions, please call 1-800-444-3353. Page 18
Troubleshooting
Problem Possible Causes Likely Solutions
Tool will not start No power at outlet.1.
Cord not connected.2.
Carbon Brushes may be worn or 3.
damaged.
Check power at outlet.1.
Check that cord is plugged in.2.
Inspect Carbon Brushes and replace if 3.
necessary.
Tool operates
slowly or
erratically.
Carbon Brushes may be worn or 1.
damaged.
Excess pressure applied to 2.
workpiece.
Inspect Carbon Brushes and replace if 1.
necessary.
Decrease pressure, allow tool to do 2.
the work.
Tool does not
grind, sand or
brush effectively.
Disc accessory may be loose on 1.
Spindle. Check tightness of Outer
Flange Arbor Nut or threaded disc
accessory on Spindle.
Disc accessory may be damaged, 2.
worn or wrong type for the
material.
Be sure disc accessory is of correct 1.
dimension and Outer Flange Arbor Nut
is tight.
Check condition and type of disc 2.
accessory. Use only proper type of
disc accessory in good condition.
Follow all safety precautions whenever diagnosing or servicing the
tool. Disconnect power supply before service.
PLEASE READ THE FOLLOWING CAREFULLY
DISTRIBUTOR MAKES ANY REPRESENTATION OR WARRANTY OF ANY KIND TO THE BUYER THAT